Five facts to collect first
A bore pump has to be matched to the bore, not just to the flow you would like. Before you ask for a quote, gather these:
- Bore diameter: the pump must fit with room for the rising main and cable
- Depth of the bore and the depth the pump will sit at
- Water level: both when the pump is off (static) and when it is running (pumping level)
- Sustainable yield: how much the bore can deliver without drawing down too far
- Water quality: sand, salinity or aggressive water changes the materials you need
Flow and head decide the duty point
Flow is how much water you need per hour. Head is the total height the pump must lift it, plus losses in the pipework and the pressure needed at the outlet. Together they give the duty point, and the pump should operate near its best efficiency point for that duty. A pump that is oversized wastes energy and wears faster.
Pump type and power source
Deep bores usually suit line-shaft turbine pumps or helical rotor pumps; smaller, shallower supplies can use submersible or transfer pumps. The power source (grid electricity or a diesel engine) affects the choice of drive and the running costs. Remote sites often favour what can be serviced locally.
Protect the investment
Run-dry protection, correct cable and starter sizing, and a sensible commissioning test keep a pump from failing early. Plan servicing too: a planned maintenance contract costs far less than an emergency pull-out. Send us your bore details and we will recommend a pump and quote the full installation.
General guidance only. Figures are illustrations; always confirm sizing and design with a qualified engineer for your site. Contact us for a site-specific recommendation.



